|
|
|
Black Pillow with Castle Embroidery Font & Lovely Lilies:
Photos and instructions for this royal pillow have been provided by Bobbie Berry from Memphis. Bobbie, thank you, thank you, thank you!
The pillow is made of black artificial silk, decorated with golden trim and monogrammed with 3 letters from Castle Embroidery Font. The bottom is decorated with lilies designs from Lovely Lilies set. Scroll down to see close-up photos, and read instructions for this project:
Instructions for making this pillow:
Cut two pieces of decorator fabric (14" x 18" size). Stitch your embroidery design(s). Cut a 3"x2" piece of fabric and fold both sides towards the middle and stitch to lower middle of front piece. See photo:
Pin decorative cord trim, right sides together, around the edge of the front piece, beginning and ending in the middle of the small flange piece. Stitch cording and clip edges. Fold flange down and stitch (On very heavy cording trim this will prevent you from having an overlap that would be difficult or impossible to sew over.) See photos:
Pin back to front, right sides together and stitch, leaving a 5" opening in the bottom. Turn right side out, through the opening. Fill with fiberfill and blind stitch opening. Finished!
Here are the links to get Castle alphabet and lilies designs used in this project.
Tips:
1. If you want to use more than one letter to make a monogram, like in this project, you may want to align and join them into a single file using your embroidery software. It's easier than aligning each one separately using the paper template method. So if you manage to keep within your largest hoop - go for it. To learn joining designs in embroidery software, click here...
2. If your fabric pieces are too small, too delicate, too slippery or too fat for hooping, you may hoop only a piece of cutaway backing, spray temporary adhesive spray on it, then stick the fabric in appropriate spot and embroider whatever you need to embroider. To get some cutaway backing and temporary adhesive spray, please visit our stabilizers section...
|
Click to view this project in printer-friendly PDF format
Or, if you prefer to save the PDF to your PC instead of printing it right away, do the following:
1. Point your mouse curson on the red link.
2. Click on your right mouse button.
3. When a small menu pops up, select the "Save Target" option.
4. Save the file to your PC, to a place you are aware of.
|
|
|
|
